Export limit exceeded: 416902 CVEs match your query. Please refine your search to export 10,000 CVEs or fewer.
Search
Search Results (416902 CVEs found)
| CVE | Vendors | Products | Updated | CVSS v3.1 |
|---|---|---|---|---|
| CVE-2026-98887 | 1 Linux | 2 Linux, Linux Kernel | 2026-10-26 | 5.5 Medium |
| In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211_hwsim: reject undersized HWSIM_ATTR_TX_INFO hwsim_tx_info_frame_received_nl() casts the HWSIM_ATTR_TX_INFO payload to a struct hwsim_tx_rate * and unconditionally reads IEEE80211_TX_MAX_RATES entries (8 bytes) from it. The policy only bounds the attribute from above (NLA_BINARY .len is a maximum) and the op sets GENL_DONT_VALIDATE_STRICT, so a short or zero-length attribute is accepted and the loop reads past the payload. Require the exact length in the policy, so a malformed attribute is rejected before the handler runs. | ||||
| CVE-2026-98878 | 1 Linux | 2 Linux, Linux Kernel | 2026-10-26 | 5.5 Medium |
| In the Linux kernel, the following vulnerability has been resolved: irqchip/gic-v5: Immediately exec priority drop following activate With GICv5 an interrupt of equal or lower priority cannot be signalled until there has been a priority drop. This is done via the GIC CDEOI system instruction. Once this has been executed, the hardware is able to signal the next interrupt if there is one. As all interrupts are programmed to have the same priority, no new interrupts can be signalled until the priority drop has happened. This can cause issues when, for example, an interrupt remains active while a long running process takes place, such as when injecting a physical interrupt into a guest VM in software. The GICv5 driver has so far done the priority drop as part of irq_eoi(), i.e., at the same time as deactivating the interrupt. This means that any long running process (or VM) could block incoming interrupts, effectively causing a denial of service for all other interrupts. Rather than doing the EOI as part of irq_eoi() (which the name would suggest would be a good place for it), move it to happen immediately after acknowledging an interrupt in the main GICv5 interrupt handler. The deactivation of interrupts (GIC CDDI) remains implemented as part of irq_eoi(), which means that the same interrupt cannot be signalled a second time until deactivated by software. | ||||
| CVE-2026-98877 | 1 Linux | 2 Linux, Linux Kernel | 2026-10-26 | 4.7 Medium |
| In the Linux kernel, the following vulnerability has been resolved: irqchip/gic-v4: Don't advertise VLPIs if no ITS is probed When accidentally setting “kvm-arm.vgic_v4_enable=1” on a system that has no MSI controller device tree node and GICv4, it results a panic as “gic_domain” is NULL and the kernel attempts to access it. Unable to handle kernel NULL pointer dereference at virtual address 0000000000000028 Mem abort info: ESR = 0x0000000096000006 CPU: 1 UID: 0 PID: 295 Comm: lkvm-static Not tainted 7.1.0-rc4-ge3f15ad3970e #5 PREEMPT Hardware name: linux,dummy-virt (DT) pstate: 81402005 (Nzcv daif +PAN -UAO -TCO +DIT -SSBS BTYPE=--) pc : __irq_domain_instantiate+0x1d4/0x578 lr : __irq_domain_instantiate+0x1cc/0x578 Set vLPI support to false at init time if the host has no ITS, so it propagates properly to kvm_vgic_global_state.has_gicv4. | ||||
| CVE-2026-98876 | 1 Linux | 2 Linux, Linux Kernel | 2026-10-26 | 4.1 Medium |
| In the Linux kernel, the following vulnerability has been resolved: host1x: bus: Fix missing ops null check in error teardown In host1x_device_init(), the error teardown paths do not check client->ops before dereferencing it, unlike the forward init paths which correctly guard with 'client->ops &&'. This can result in a NULL pointer dereference if client->ops is NULL. Fix by adding the missing client->ops check in both the teardown and teardown_late labels. | ||||
| CVE-2026-98875 | 1 Linux | 2 Linux, Linux Kernel | 2026-10-26 | 4.4 Medium |
| In the Linux kernel, the following vulnerability has been resolved: drm/nouveau/gsp: add SEC2 to GA100 chip table The booter-load and booter-unload firmware run on the SEC2 falcon. During tu102_gsp_oneinit(), the booter constructor needs device->sec2 to access the SEC2 falcon. Without the .sec2 entry, device->sec2 is NULL and this dereference crashes during GSP-RM boot. | ||||
| CVE-2026-66592 | 2 Rtcamp, Wordpress | 2 Rtmedia For Wordpress, Buddypress And Bbpress, Wordpress | 2026-10-26 | 9.3 Critical |
| Improper Neutralization of Special Elements used in an SQL Command ('SQL Injection') vulnerability in rtCamp Inc. rtMedia for WordPress, BuddyPress and bbPress buddypress-media allows Blind SQL Injection.This issue affects rtMedia for WordPress, BuddyPress and bbPress: from n/a through 4.7.11. | ||||
| CVE-2026-28177 | 2 Daniel Iser, Wordpress | 2 Popup Maker, Wordpress | 2026-10-26 | 7.1 High |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in Code Atlantic LLC Popup Maker popup-maker allows DOM-Based XSS.This issue affects Popup Maker: from n/a through 1.23.0. | ||||
| CVE-2026-116228 | 1 777genius | 1 Agent-teams-ai | 2026-10-26 | 3.3 Low |
| A vulnerability was found in 777genius agent-teams-ai up to 2.17.10. This issue affects the function doStart of the file src/main/services/infrastructure/HttpServer.ts of the component Local HTTP Service. The manipulation results in missing authentication. The attack is only possible with local access. The exploit has been made public and could be used. The vendor was contacted early about this disclosure but did not respond in any way. | ||||
| CVE-2026-116223 | 1 Icret | 1 Easyimage | 2026-10-26 | 6.5 Medium |
| A flaw has been found in icret EasyImage up to 2.8.7. The impacted element is an unknown function of the file app/del.php. Executing a manipulation of the argument hash can lead to improper privilege management. The attack can be launched remotely. The exploit has been published and may be used. This patch is called b12cb67d447bcbb67e21c8f011d0f5638229760c. A patch should be applied to remediate this issue. | ||||
| CVE-2026-116122 | 1 Nocodb | 1 Nocodb | 2026-10-26 | 3.7 Low |
| A security flaw has been discovered in NocoDB up to 2026.07.0. Impacted is the function AuthService.validateUser of the component Sign-in Endpoint. Performing a manipulation of the argument salt results in information disclosure. It is possible to initiate the attack remotely. The attack's complexity is rated as high. The exploitability is considered difficult. The vendor deleted the GitHub issue for this vulnerability without any explanation. Afterwards the vendor was contacted early about this disclosure via email but did not respond in any way. | ||||
| CVE-2026-116119 | 1 Nocodb | 1 Nocodb | 2026-10-26 | 5.5 Medium |
| A vulnerability was found in NocoDB up to 2026.08.0. This affects an unknown part of the file packages/nocodb/src/services/users/users.service.ts of the component Password-Reset Flow. The manipulation results in race condition. The attack can be executed remotely. The vendor deleted the GitHub issue for this vulnerability without any explanation. Afterwards the vendor was contacted early about this disclosure via email but did not respond in any way. | ||||
| CVE-2026-101295 | 2 Oc-mirror, Redhat | 4 Oc-mirror, Assisted Installer, Openshift and 1 more | 2026-10-26 | 7.3 High |
| Path traversal / arbitrary file write in oc-mirror's operator catalog image extraction. When mirroring operator catalogs using either the legacy v1 path (--v1) or the OCI feature path (--use-oci-feature), oc-mirror extracts tar entries from catalog image layers without validating that file paths resolve within the intended destination directory. | ||||
| CVE-2026-116116 | 1 Yoosee | 1 Gm8135s Camera | 2026-10-26 | 8.2 High |
| A vulnerability was detected in Yoosee GM8135S Camera 21.00.01.36. Affected is an unknown function of the component Secure Boot. Performing a manipulation results in improper verification of cryptographic signature. The attack needs to be approached locally. The exploit is now public and may be used. The vendor was contacted early about this disclosure but did not respond in any way. | ||||
| CVE-2026-103869 | 2 Red Hat, Redhat | 3 Red Hat Satellite 6, Ansible Automation Platform, Satellite | 2026-10-26 | 6.5 Medium |
| A flaw was found in pulp-ansible's bearer-token refresh for collection remotes. The access token is kept in one module-level variable and reused for every token download in that worker. A user who can sync an Ansible remote that uses token refresh, and can point that remote at a server they control, receives an access token obtained for a different remote, and can reuse it at the service that issued it. Content stored in Pulp is not changed, and the service is not stopped. | ||||
| CVE-2026-55655 | 3 Openbsd, Openssh, Redhat | 12 Openssh, Openssh, Enterprise Linux and 9 more | 2026-10-26 | 5 Medium |
| A flaw was found in OpenSSH. A local unprivileged attacker on a Linux client host can hijack client-side X11 forwarding connections. This is possible by pre-binding the preferred abstract X socket name when X11 forwarding is enabled and a local UNIX-domain X socket is used. A successful attack can compromise the confidentiality of forwarded X11 traffic, including sensitive window contents and input, and may allow some manipulation of the forwarded session. | ||||
| CVE-2026-55653 | 3 Openbsd, Openssh, Redhat | 12 Openssh, Openssh, Enterprise Linux and 9 more | 2026-10-26 | 4.3 Medium |
| A flaw was found in OpenSSH. A malicious SSH server can exploit a double free vulnerability in the Diffie-Hellman Group Exchange (DH-GEX) client path. This occurs during FIPS (Federal Information Processing Standards) mode known-group validation when the client processes attacker-controlled DH-GEX group parameters. Successful exploitation leads to client-side process termination, resulting in a Denial of Service (DoS). | ||||
| CVE-2026-116113 | 1 Gouguoa | 1 Gouguoa | 2026-10-26 | 6.3 Medium |
| A security flaw has been discovered in GouGuOA up to 6.1.2. The impacted element is the function chunkUpload of the file app/disk/controller/Api.php. The manipulation of the argument file_extension results in unrestricted upload. It is possible to launch the attack remotely. The exploit has been released to the public and may be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. | ||||
| CVE-2026-116110 | 1 Giantappman | 1 Livewallpaper | 2026-10-26 | 7.3 High |
| A vulnerability was found in GiantappMan LiveWallPaper 2.6.8.0 on Windows. This issue affects some unknown processing of the file /LiveWallpaper/UploadFile of the component SignalR Hub. Performing a manipulation results in missing authentication. The attack is possible to be carried out remotely. The exploit has been made public and could be used. The patch is named b62f878899adbfc2968e3345442f3a3df91b774d. It is suggested to install a patch to address this issue. The vendor was contacted early about this disclosure. | ||||
| CVE-2026-72844 | 1 Leanprover | 1 Lean4 | 2026-10-26 | 6.3 Medium |
| The Lean 4 kernel does not verify that the structure named in a projection expression matches the type of the value being projected, and environment::add_inductive in src/kernel/inductive.cpp did not type check the nested inductive applications that are replaced by auxiliary types, so their parametric arguments escaped checking. A metaprogram running in the Lean process can register an ill-typed nested inductive whose constructor applies a .proj C 0 projection to a value of the unrelated type W, and the kernel admits the declaration through the ordinary checked addDecl path at maximum kernel checking, without sorry, unsafeCast, debug.skipKernelTC, addDeclWithoutChecking, FFI, or a modified .olean file. The result is a type confusion yielding a proof of False that carries no axioms, from which any proposition can be derived. The published proof of concept additionally pads two expressions until their hashes and approximate depths collide, which defeats kernel caching; that is the technique used to reach the flaw, not its cause. Exploitation requires running a metaprogram in-process, for example by building a project or importing a malicious Lake dependency. | ||||
| CVE-2026-72714 | 1 Rocq-prover | 1 Rocq | 2026-10-26 | 6.3 Medium |
| Rocq Prover does not restore the universe graph's copy of the universe checking flag when a module that locally disabled the check is closed. Local Unset Universe Checking inside a module is expected to last only until the module ends, and the global flag is restored, but the universe graph keeps its own copy which is left disabled. The two views then disagree: Test Universe Checking reports the check as enabled while the kernel continues to accept universe-inconsistent terms. With the constraint between two universes no longer enforced, Hurkens' paradox applies and yields a proof of False, from which any proposition follows. The proof uses no axioms, plugins or unsafe features once the module has closed, and Print Assumptions reports it as closed under the global context, so neither the assumption audit nor the flag query reflects the actual kernel state. No fix is available. | ||||