| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211_hwsim: reject undersized HWSIM_ATTR_TX_INFO
hwsim_tx_info_frame_received_nl() casts the HWSIM_ATTR_TX_INFO payload
to a struct hwsim_tx_rate * and unconditionally reads
IEEE80211_TX_MAX_RATES entries (8 bytes) from it. The policy only bounds
the attribute from above (NLA_BINARY .len is a maximum) and the op sets
GENL_DONT_VALIDATE_STRICT, so a short or zero-length attribute is
accepted and the loop reads past the payload.
Require the exact length in the policy, so a malformed attribute is
rejected before the handler runs. |
| In the Linux kernel, the following vulnerability has been resolved:
irqchip/gic-v5: Immediately exec priority drop following activate
With GICv5 an interrupt of equal or lower priority cannot be signalled
until there has been a priority drop. This is done via the GIC CDEOI
system instruction. Once this has been executed, the hardware is able
to signal the next interrupt if there is one.
As all interrupts are programmed to have the same priority, no new
interrupts can be signalled until the priority drop has happened. This
can cause issues when, for example, an interrupt remains active while
a long running process takes place, such as when injecting a physical
interrupt into a guest VM in software.
The GICv5 driver has so far done the priority drop as part of
irq_eoi(), i.e., at the same time as deactivating the interrupt. This
means that any long running process (or VM) could block incoming
interrupts, effectively causing a denial of service for all other
interrupts.
Rather than doing the EOI as part of irq_eoi() (which the name would
suggest would be a good place for it), move it to happen immediately
after acknowledging an interrupt in the main GICv5 interrupt
handler. The deactivation of interrupts (GIC CDDI) remains implemented
as part of irq_eoi(), which means that the same interrupt cannot be
signalled a second time until deactivated by software. |
| In the Linux kernel, the following vulnerability has been resolved:
irqchip/gic-v4: Don't advertise VLPIs if no ITS is probed
When accidentally setting “kvm-arm.vgic_v4_enable=1” on a system that has
no MSI controller device tree node and GICv4, it results a panic as
“gic_domain” is NULL and the kernel attempts to access it.
Unable to handle kernel NULL pointer dereference at virtual address 0000000000000028
Mem abort info:
ESR = 0x0000000096000006
CPU: 1 UID: 0 PID: 295 Comm: lkvm-static Not tainted 7.1.0-rc4-ge3f15ad3970e #5 PREEMPT
Hardware name: linux,dummy-virt (DT)
pstate: 81402005 (Nzcv daif +PAN -UAO -TCO +DIT -SSBS BTYPE=--)
pc : __irq_domain_instantiate+0x1d4/0x578
lr : __irq_domain_instantiate+0x1cc/0x578
Set vLPI support to false at init time if the host has no ITS, so it
propagates properly to kvm_vgic_global_state.has_gicv4. |
| In the Linux kernel, the following vulnerability has been resolved:
host1x: bus: Fix missing ops null check in error teardown
In host1x_device_init(), the error teardown paths do not check
client->ops before dereferencing it, unlike the forward init paths
which correctly guard with 'client->ops &&'. This can result in a
NULL pointer dereference if client->ops is NULL.
Fix by adding the missing client->ops check in both the teardown
and teardown_late labels. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau/gsp: add SEC2 to GA100 chip table
The booter-load and booter-unload firmware run on the SEC2 falcon.
During tu102_gsp_oneinit(), the booter constructor needs device->sec2
to access the SEC2 falcon.
Without the .sec2 entry, device->sec2 is NULL and this dereference
crashes during GSP-RM boot. |
| Improper Neutralization of Special Elements used in an SQL Command ('SQL Injection') vulnerability in rtCamp Inc. rtMedia for WordPress, BuddyPress and bbPress buddypress-media allows Blind SQL Injection.This issue affects rtMedia for WordPress, BuddyPress and bbPress: from n/a through 4.7.11. |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in Code Atlantic LLC Popup Maker popup-maker allows DOM-Based XSS.This issue affects Popup Maker: from n/a through 1.23.0. |
| A vulnerability was found in 777genius agent-teams-ai up to 2.17.10. This issue affects the function doStart of the file src/main/services/infrastructure/HttpServer.ts of the component Local HTTP Service. The manipulation results in missing authentication. The attack is only possible with local access. The exploit has been made public and could be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| A flaw has been found in icret EasyImage up to 2.8.7. The impacted element is an unknown function of the file app/del.php. Executing a manipulation of the argument hash can lead to improper privilege management. The attack can be launched remotely. The exploit has been published and may be used. This patch is called b12cb67d447bcbb67e21c8f011d0f5638229760c. A patch should be applied to remediate this issue. |
| A security flaw has been discovered in NocoDB up to 2026.07.0. Impacted is the function AuthService.validateUser of the component Sign-in Endpoint. Performing a manipulation of the argument salt results in information disclosure. It is possible to initiate the attack remotely. The attack's complexity is rated as high. The exploitability is considered difficult. The vendor deleted the GitHub issue for this vulnerability without any explanation. Afterwards the vendor was contacted early about this disclosure via email but did not respond in any way. |
| A vulnerability was found in NocoDB up to 2026.08.0. This affects an unknown part of the file packages/nocodb/src/services/users/users.service.ts of the component Password-Reset Flow. The manipulation results in race condition. The attack can be executed remotely. The vendor deleted the GitHub issue for this vulnerability without any explanation. Afterwards the vendor was contacted early about this disclosure via email but did not respond in any way. |
| Path traversal / arbitrary file write in oc-mirror's operator catalog image extraction. When mirroring operator catalogs using either the legacy v1 path (--v1) or the OCI feature path (--use-oci-feature), oc-mirror extracts tar entries from catalog image layers without validating that file paths resolve within the intended destination directory. |
| A vulnerability was detected in Yoosee GM8135S Camera 21.00.01.36. Affected is an unknown function of the component Secure Boot. Performing a manipulation results in improper verification of cryptographic signature. The attack needs to be approached locally. The exploit is now public and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| A flaw was found in pulp-ansible's bearer-token refresh for collection remotes. The access token is kept in one module-level variable and reused for every token download in that worker. A user who can sync an Ansible remote that uses token refresh, and can point that remote at a server they control, receives an access token obtained for a different remote, and can reuse it at the service that issued it. Content stored in Pulp is not changed, and the service is not stopped. |
| A flaw was found in OpenSSH. A local unprivileged attacker on a Linux client host can hijack client-side X11 forwarding connections. This is possible by pre-binding the preferred abstract X socket name when X11 forwarding is enabled and a local UNIX-domain X socket is used. A successful attack can compromise the confidentiality of forwarded X11 traffic, including sensitive window contents and input, and may allow some manipulation of the forwarded session. |
| A flaw was found in OpenSSH. A malicious SSH server can exploit a double free vulnerability in the Diffie-Hellman Group Exchange (DH-GEX) client path. This occurs during FIPS (Federal Information Processing Standards) mode known-group validation when the client processes attacker-controlled DH-GEX group parameters. Successful exploitation leads to client-side process termination, resulting in a Denial of Service (DoS). |
| A security flaw has been discovered in GouGuOA up to 6.1.2. The impacted element is the function chunkUpload of the file app/disk/controller/Api.php. The manipulation of the argument file_extension results in unrestricted upload. It is possible to launch the attack remotely. The exploit has been released to the public and may be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was found in GiantappMan LiveWallPaper 2.6.8.0 on Windows. This issue affects some unknown processing of the file /LiveWallpaper/UploadFile of the component SignalR Hub. Performing a manipulation results in missing authentication. The attack is possible to be carried out remotely. The exploit has been made public and could be used. The patch is named b62f878899adbfc2968e3345442f3a3df91b774d. It is suggested to install a patch to address this issue. The vendor was contacted early about this disclosure. |
| The Lean 4 kernel does not verify that the structure named in a projection expression matches the type of the value being projected, and environment::add_inductive in src/kernel/inductive.cpp did not type check the nested inductive applications that are replaced by auxiliary types, so their parametric arguments escaped checking. A metaprogram running in the Lean process can register an ill-typed nested inductive whose constructor applies a .proj C 0 projection to a value of the unrelated type W, and the kernel admits the declaration through the ordinary checked addDecl path at maximum kernel checking, without sorry, unsafeCast, debug.skipKernelTC, addDeclWithoutChecking, FFI, or a modified .olean file. The result is a type confusion yielding a proof of False that carries no axioms, from which any proposition can be derived. The published proof of concept additionally pads two expressions until their hashes and approximate depths collide, which defeats kernel caching; that is the technique used to reach the flaw, not its cause. Exploitation requires running a metaprogram in-process, for example by building a project or importing a malicious Lake dependency. |
| Rocq Prover does not restore the universe graph's copy of the universe checking flag when a module that locally disabled the check is closed. Local Unset Universe Checking inside a module is expected to last only until the module ends, and the global flag is restored, but the universe graph keeps its own copy which is left disabled. The two views then disagree: Test Universe Checking reports the check as enabled while the kernel continues to accept universe-inconsistent terms. With the constraint between two universes no longer enforced, Hurkens' paradox applies and yields a proof of False, from which any proposition follows. The proof uses no axioms, plugins or unsafe features once the module has closed, and Print Assumptions reports it as closed under the global context, so neither the assumption audit nor the flag query reflects the actual kernel state. No fix is available. |
