| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Out of bounds read in WebGL in Google Chrome prior to 154.0.8037.92 allowed a remote attacker to read memory outside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| IBM Server Firmware FW1120.00 through FW1120.01, FW1110.00 through FW1110.31, FW1060.00 through FW1060.81, and FW950.00 through FW950.H3 is affected by a vulnerability in the ASMI web interface. An unauthenticated attacker on the management network can send a malformed HTTPS request to ASMI, causing the web server to crash with possible memory corruption and generate an error log. The ASMI web interface will restart automatically; however, repeated exploitation could result in a sustained loss of access to the ASMI management interface, resulting in an integrity and availability impact. |
| The MCUmgr SMP-over-console transport decodes a base64 frame, reads a 16-bit packet length from it, verifies a CRC and then unconditionally strips the trailing CRC with rx_ctxt->nb->len -= 2U; in mcumgr_serial_process_frag() (subsys/mgmt/mcumgr/transport/src/serial_util.c). mcumgr_serial_extract_len() accepted any declared length, including 0 and 1, and a packet declaring length 0 passes the checksum test for free because crc16_itu_t() over zero bytes returns the zero seed. Since net_buf::len is a uint16_t, the subtraction underflows and the buffer is handed to SMP claiming roughly 65 KB of payload while its data area is only CONFIG_MCUMGR_TRANSPORT_NETBUF_SIZE bytes (default 384).
The trigger is a single unauthenticated 7-byte line on the management console — the 0x06 0x09 packet marker followed by the base64 group AAA= and a newline — delivered to any transport built on this helper: CONFIG_MCUMGR_TRANSPORT_UART (smp_uart.c) or CONFIG_MCUMGR_TRANSPORT_SHELL (smp_shell.c), both of which select MCUMGR_TRANSPORT_SERIAL_HAS_SMP_OVER_CONSOLE. No prior session state, fragmentation or credentials are required to trigger the underflow, and the malformed frame is mishandled before any command handler or command-level access control runs. The attacker only needs write access to that console, which on many boards is a USB CDC-ACM port rather than a bare UART header.
With the inflated length, smp_process_request_packet() in subsys/mgmt/mcumgr/smp/src/smp.c loses its bound: cbor_nb_reader_init() gives the CBOR decoder a ~65 KB window into a 384-byte buffer, and each request header's nh_len is checked only against the inflated length. On its own the 7-byte frame re-parses whatever stale bytes the reused pool buffer still holds, typically a replay of the previously received request followed by a parse error, without leaving the buffer. Because the transport is unauthenticated, though, the attacker also controls the frames sent before the trigger, and can stage buffer contents so that a request succeeds with an nh_len larger than the buffer; net_buf_pull(), guarded only by __ASSERT_NO_MSG, then moves the parse cursor out of bounds and the loop reads further headers and CBOR from adjacent memory. The consequence is an out-of-bounds read that can fault the MCUmgr thread (denial of service); memory disclosure is also possible, since the default-enabled os echo handler (CONFIG_MCUMGR_GRP_OS_ECHO) decodes its string inside that window and copies it into its response. There is no integrity gain beyond what the unauthenticated transport already permits.
The fix rejects any declared packet length of two bytes or fewer in mcumgr_serial_extract_len(), so the CRC-strip subtraction can no longer underflow. The identical pattern remains in the test-only loopback transport subsys/mgmt/mcumgr/transport/src/smp_dummy.c (CONFIG_MCUMGR_TRANSPORT_DUMMY), which has no external input path and therefore carries no practical exposure. |
| An out-of-bounds read in libXtst's RECORD reply parser in libXtst before 1.2.6 could be used by malicious X servers to crash attached X clients. |
| An out-of-bounds read in libX11's byte-oriented codeset parser in libX11 before 1.8.14 could be used by malicious X servers to crash attached X clients. |
| An out-of-bounds read vulnerability in libX11's XIM trigger-key registration parser in libX11 before 1.8.14 could be used by malicious X servers to crash attached X clients. |
| An out-of-bounds read vulnerability in libX11's XIM (X Input Method) attribute parser in libX11 before 1.8.14 could be used by malicious X servers to crash attached X clients. |
| Out-of-bounds read in Microsoft Standard XPS allows an authorized attacker to disclose information locally. |
| Out-of-bounds read in Push Message Routing Service allows an authorized attacker to disclose information locally. |
| Out-of-bounds read in Microsoft Standard XPS allows an authorized attacker to disclose information locally. |
| Out-of-bounds read in Remote Desktop Client allows an authorized attacker to disclose information over a network. |
| Out-of-bounds read in BranchCache allows an unauthorized attacker to deny service over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Don't predict JMP32 pointer vs zero comparisons
Consider the following program:
r1 = map_value; /* low 32 bits are zero at runtime */
r6 = 0xdead000000000000;
if w1 != 0 goto l1;
l0: r1 += r6;
r2 = *(u64 *)(r1 + 0);
exit;
l1: r6 = 0;
goto l0;
At the moment is_branch_taken() reports the jump as always taken,
because it does not distinguish between BPF_JMP and BPF_JMP32
comparisons when processing 'if w1 != 0 ...'. |
| In the Linux kernel, the following vulnerability has been resolved:
accel/amdxdna: reject a command chain that carries no commands
A chain whose command_count is zero passes the payload length check,
because struct_size(payload, data, 0) is just the header. The fill loop
then does not run, so offset stays zero and the request is submitted with
a zero-length buffer.
On firmware without AIE2_NPU_COMMAND that ends at the opcode check, since
op is still ERT_INVALID_CMD and aie2_get_chain_msg_op() answers
MSG_OP_MAX_OPCODE. aie2_get_npu_chain_msg_op() answers
MSG_OP_CHAIN_EXEC_NPU whatever it is given, so there the submission
continues to drm_clflush_virt_range(cmd_buf, 0), which reads the byte
before the buffer and faults on the vmap guard page. EXEC_CMD is
reachable by any process that can open the render node.
Reject the request instead. |
| In the Linux kernel, the following vulnerability has been resolved:
cachefiles: Fix potential UAF/KASAN warning
Currently, trace_cachefiles_coherency() is being passed a pointer to a
__be64 lain over the coherency data in struct cachefiles_xattr so that it
can display the first 8 bytes. However, the data is of variable length and
could even be 0 bytes. This could lead to a UAF or KASAN warning.
Fix this by making sure the buffer has room for at least 8 bytes and that
those 8 bytes are pre-cleared.
Further, those bytes are not 8-byte aligned, so fix the tracepoint to
extract the data as four 2-byte words (they are 2-byte aligned) and
reassemble the __be64. The compiler will convert this into a single 8-byte
load where the CPU supports it. |
| A DHCP server, or anyone on the LAN who answers a DISCOVER first, can make the client read about a
kilobyte past the end of the received message.
The option walk keeps a pointer and an offset in step, and the only bound check uses the offset:
```c
/* addons/dhcp/nxd_dhcp_client.c:7538, 7572 */
while (i < length - 1)
{
...
size = *(++data); /* data moves 1: type -> length byte */
data += size + 1; /* data moves size + 1 more */
i += size + 1; /* i moves only size + 1 */
}
```
A TLV option occupies size + 2 bytes. `data` is advanced by size + 2 in total, `i` by size + 1, so
the offset falls one byte behind the real read position for every option the walk skips. After
enough skipped options the check `i < length - 1` still holds while `data` is already past the end
of the message, and the subsequent read of the type and length bytes comes from whatever follows.
A single OFFER carrying a long run of skippable options is enough:
```
ERROR: AddressSanitizer: heap-buffer-overflow
READ of size 1 at 0x61b000000794 thread T5
#0 _nx_dhcp_search_buffer addons/dhcp/nxd_dhcp_client.c:7541
#1 _nx_dhcp_get_option_value addons/dhcp/nxd_dhcp_client.c:7082
0x61b000000794 is located 164 bytes to the right of 1648-byte region
```
A well formed OFFER through the same path is handled normally, the client records the offer and
moves to REQUESTING, so the difference is the option layout rather than the harness.
The read runs in the DHCP client thread while the client is still unconfigured, so it happens on
every boot in reach of a hostile DHCP responder. The values read are used to configure the
interface, which is how the disclosed bytes become observable.
Advance `i` by size + 2, or derive the bound from `data` rather than keeping a second counter. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel: bound firmware ID by TLV length
The firmware ID is treated as a NUL-terminated string even though the
TLV length is its only boundary. If the value does not contain a NUL
terminator, snprintf() can read beyond the received response.
Limit the conversion to the advertised TLV value length. |
| Russh is a Rust SSH client and server library. Prior to 0.63.1, a connection configured to permit mac=none can negotiate it with a MAC-requiring CTR or CBC block cipher because the selection logic validates needs_mac() only when MAC selection fails. A remote peer can then send a packet with a decrypted length of zero, causing russh/src/cipher/mod.rs to shrink the previously read block before indexing buffer.buffer[16..], which panics and terminates the connection task. This issue is fixed in version 0.63.1. |
| In the Linux kernel, the following vulnerability has been resolved:
perf: RISC-V: store available counter mask as bitmap
The available-counter mask was a single unsigned long, but iteration
uses RISCV_MAX_COUNTERS, which is 64. On RV32 that reads past the object.
Filling with an unsigned-long bit at index 32 and above is also wrong.
Use DECLARE_BITMAP and set_bit/bitmap helpers. Walk each bitmap word
into CFG_MATCH when checking events, when allocating an index, and when
stopping all counters. Set the counter base to i times BITS_PER_LONG.
Share the CFG_MATCH ecall through a small helper so the 32-bit argument
split is not duplicated. On qemu-system-riscv32 the probe bitmap has bits
above XLEN set, so the first word alone is not enough.
[pjw@kernel.org: updated to apply; fixed checkpatch.pl issues] |
| Out-of-bounds read in Microsoft Standard XPS allows an authorized attacker to disclose information locally. |
